<![CDATA[IAX2 trunk shows outbound only]]>I have a single IAX trunk connecting two Asterisk systems configured as peers. Only the outbound traffic is displayed in FOP2. How can I have the inbound traffic displayed as well? Thanks.

]]>https://forum.fop2.com/topic/1549/iax2-trunk-shows-outbound-onlyRSS for NodeTue, 27 Oct 2026 18:27:27 GMTFri, 02 Aug 2013 15:45:04 GMT60<![CDATA[Reply to IAX2 trunk shows outbound only on Thu, 15 Aug 2013 21:21:07 GMT]]>

I too have this issue, using PIAF, outgoing works fine, but i am a bit stumped about how to find the IAX2/name for the inbound... can it be gleaned from the logs? is it the context name of the incoming call?

any help would be greatly appreciated.

Run this command when you have inbound iax calls:

asterisk -rx "core show channels"
]]>https://forum.fop2.com/post/6755https://forum.fop2.com/post/6755Thu, 15 Aug 2013 21:21:07 GMT<![CDATA[Reply to IAX2 trunk shows outbound only on Fri, 09 Aug 2013 15:14:43 GMT]]>I too have this issue, using PIAF, outgoing works fine, but i am a bit stumped about how to find the IAX2/name for the inbound... can it be gleaned from the logs? is it the context name of the incoming call?

any help would be greatly appreciated.

]]>https://forum.fop2.com/post/6754https://forum.fop2.com/post/6754Fri, 09 Aug 2013 15:14:43 GMT<![CDATA[Reply to IAX2 trunk shows outbound only on Wed, 07 Aug 2013 01:48:06 GMT]]>Inbound traffic is probably not matching the iax peer in your configuration (and has a different channel name, perhaps IAX2/ip.add.re.ss). Either add the extra name in the channel field in fop2admin fop2 buttons page, or configure your iax peer so it matches both inbound and outbound calls.

Best regards,

]]>https://forum.fop2.com/post/6753https://forum.fop2.com/post/6753Wed, 07 Aug 2013 01:48:06 GMT