<![CDATA[Changing Attended Transfer key sequence from asterisk default]]>Hi

As I understand it, FOP2 uses the key sequence as defined in the features.conf to initiate an attended transfer, and it uses the default which is a single #

If I want to change this in the features.conf, is there a way to make the same change in the fop2 config?

Thanks in Advance

Ish

]]>http://localhost:4567/topic/2190/changing-attended-transfer-key-sequence-from-asterisk-defaultRSS for NodeTue, 27 Oct 2026 15:00:47 GMTWed, 09 Mar 2016 12:19:35 GMT60<![CDATA[Reply to Changing Attended Transfer key sequence from asterisk default on Fri, 11 Mar 2016 15:33:57 GMT]]>Thank you for your rapid help, my issue is resolved now.

]]>http://localhost:4567/post/9637http://localhost:4567/post/9637Fri, 11 Mar 2016 15:33:57 GMT<![CDATA[Reply to Changing Attended Transfer key sequence from asterisk default on Thu, 10 Mar 2016 21:06:25 GMT]]>Blind transfers in FOP2 are done using the manager Redirect command. It does not use any feature code.

]]>http://localhost:4567/post/9636http://localhost:4567/post/9636Thu, 10 Mar 2016 21:06:25 GMT<![CDATA[Reply to Changing Attended Transfer key sequence from asterisk default on Thu, 10 Mar 2016 16:52:37 GMT]]>Actually it's blind transfer that defaults to # but I'm guessing the same principle applies...

;blindxfer => #1 ; Blind transfer (default is #) -- Make sure to set the T and/or t option in the Dial() or Queue() app call!

]]>http://localhost:4567/post/9635http://localhost:4567/post/9635Thu, 10 Mar 2016 16:52:37 GMT<![CDATA[Reply to Changing Attended Transfer key sequence from asterisk default on Thu, 10 Mar 2016 16:48:16 GMT]]>That makes sense, I'll test it now.

]]>http://localhost:4567/post/9634http://localhost:4567/post/9634Thu, 10 Mar 2016 16:48:16 GMT<![CDATA[Reply to Changing Attended Transfer key sequence from asterisk default on Wed, 09 Mar 2016 22:51:50 GMT]]>FOP2 does not know the code sequence, it does not have to. It uses the atxfer AMI command and whatever code is configured is read by that command/asterisk itself. So, if you change the feature code, then I guess asterisk will just use the configured code, whichever it is. For example, on my system is not a single # but *2

]]>http://localhost:4567/post/9633http://localhost:4567/post/9633Wed, 09 Mar 2016 22:51:50 GMT