<![CDATA[BUG: Empty labels get re-populated in FreePBX Module]]>FOP 2.20.

If I clear a label in the FreePBX Module it appears to get saved properly but the input box gets re-populated and so the next time I make a change the label gets re-added.

I tested a user and a trunk and the behavior is the same in each case.

]]>http://localhost:4567/topic/677/bug-empty-labels-get-re-populated-in-freepbx-moduleRSS for NodeTue, 27 Oct 2026 10:28:33 GMTThu, 10 Mar 2011 18:21:26 GMT60<![CDATA[Reply to BUG: Empty labels get re-populated in FreePBX Module on Fri, 11 Mar 2011 21:36:05 GMT]]>Perhaps an active/inactive flag instead?

]]>http://localhost:4567/post/2966http://localhost:4567/post/2966Fri, 11 Mar 2011 21:36:05 GMT<![CDATA[Reply to BUG: Empty labels get re-populated in FreePBX Module on Fri, 11 Mar 2011 21:10:51 GMT]]>Following up on this:

Empty labels are replaced with the FreePBX label when you load the buttons page. That is done on purpose. But as removing the label is also a way to prevent a button from showing in the panel without setting up groups, then I might revise this option. What do you think? Blank labels must be preserved ?

]]>http://localhost:4567/post/2965http://localhost:4567/post/2965Fri, 11 Mar 2011 21:10:51 GMT<![CDATA[Reply to BUG: Empty labels get re-populated in FreePBX Module on Fri, 11 Mar 2011 20:03:15 GMT]]>You are right... I am not sure to call this a bug or a feature. I will see what can I do as I think that mantaining the empty label is what must happen, but I also need new buttons added if there are any. I will experiment a little bit , and let you know if there are updates to the module in the near future.

]]>http://localhost:4567/post/2964http://localhost:4567/post/2964Fri, 11 Mar 2011 20:03:15 GMT