Starting fop2_server show bad operators state
Hello.
Why when I start fop2_server, fop2 show that all operators are available (green buttons), but real all operators are not connected to asterisk
sip show peers
Name/username Host Dyn Forcerport ACL Port Status Description
operator01 (Unspecified) D N A 0 UNKNOWN
operator02 (Unspecified) D N A 0 UNKNOWN
operator03 (Unspecified) D N A 0 UNKNOWN
operator04 (Unspecified) D N A 0 UNKNOWN
operator05 (Unspecified) D N A 0 UNKNOWN
If I connect and disconnect from asterisk, that fop2 shows real state that operator. Other operators are still in green state but realy are disconnected. And I need do this procedure with all operators.
Please help me.
Why when I start fop2_server, fop2 show that all operators are available (green buttons), but real all operators are not connected to asterisk
sip show peers
Name/username Host Dyn Forcerport ACL Port Status Description
operator01 (Unspecified) D N A 0 UNKNOWN
operator02 (Unspecified) D N A 0 UNKNOWN
operator03 (Unspecified) D N A 0 UNKNOWN
operator04 (Unspecified) D N A 0 UNKNOWN
operator05 (Unspecified) D N A 0 UNKNOWN
If I connect and disconnect from asterisk, that fop2 shows real state that operator. Other operators are still in green state but realy are disconnected. And I need do this procedure with all operators.
Please help me.
Comments
Not sure if I totally understand your issue. If you want to see sip registration status, you must set qualify=yes to the sip peer configuration in sip.conf. If you use asterisk realtime for them, you have to set rtcachefriends=yes. If that is correctly set, then you will see registered/unregistered status on buttons in fop2.
Best regards,
In the asterisk manager.conf file for fop2 account write permissions have been commented out :oops: .
Thanks