Hangup bug?

FreerPBXerFreerPBXer
in Support
Running 2.26 against FreePBX 2.210.62-5 and Asterisk 10.12.0

When I hangup a call by selecting the line button and clicking the Hangup button, the calls shows as disconnected in FOP2, but it doesn't disconnect; it continues to operate until it's disconnected from a handset at either end.

Comments

  • nicolasnicolas
    If FOP2 shows it as hang up then asterisk is sending the hangup event in AMI, that means that the command is accepted and performed by asterisk. If the channel gets stuck or whatever after that, it is an Asterisk issue or a configuration issue within asterisk itself. Not related to fop2.

    Think FOP2 as a command center. FOP2 sends the hangup command, if asterisk then does a "partial" hangup, the problem lies in Asterisk. The same applies to every other command, if FOP2 sends the proper command and asterisk gets emotional, it is an asterisk problem, not FOP2.

    By your description, I would guess that you have a misconfiguration issue with your channel drivers.

    Best regards,
Sign In or Register to comment.

© Asternic Corp 2024