IAX2 trunk shows outbound only

turbocturboc
in Support
I have a single IAX trunk connecting two Asterisk systems configured as peers. Only the outbound traffic is displayed in FOP2. How can I have the inbound traffic displayed as well? Thanks.

Comments

  • nicolasnicolas
    Inbound traffic is probably not matching the iax peer in your configuration (and has a different channel name, perhaps IAX2/ip.add.re.ss). Either add the extra name in the channel field in fop2admin fop2 buttons page, or configure your iax peer so it matches both inbound and outbound calls.

    Best regards,
  • ashleydreesashleydrees
    I too have this issue, using PIAF, outgoing works fine, but i am a bit stumped about how to find the IAX2/name for the inbound... can it be gleaned from the logs? is it the context name of the incoming call?

    any help would be greatly appreciated.
  • nicolasnicolas
    I too have this issue, using PIAF, outgoing works fine, but i am a bit stumped about how to find the IAX2/name for the inbound... can it be gleaned from the logs? is it the context name of the incoming call?

    any help would be greatly appreciated.

    Run this command when you have inbound iax calls:
    asterisk -rx "core show channels"
Sign In or Register to comment.

© Asternic Corp 2024