dahdi trunk buttons not showing anything

sgladio

I apologize if this has been covered in another post, I was not able to find anything after extensive searching...

I have FOP2 installed on my PIAF (purple) server and I am using a combination of SIP and Analog lines. Asterisk is working fine, I can make and receive calls on both SIP and DAHDi.

I am using a Digium 8 port card and it is configured with all 8 ports in g0.

FOP2 displays calls in the SIP trunk perfectly, however it does not display anything in the DAHDi trunk button.

I have tried adding every permutation of "ZAP/DAHDi Channels" to the configuration in the FreePBX module for FOP2 but it never seems to "stick". As soon as I hit "Submit" it goes blank the Dahdi trunk button never shows any calls in or out.

I'm sure I am missing something simple here but for the life of me I can't seem to figure it out.

Any help is greatly appreciated!

Thanks!

nicolas

You have to set the channel range in the fop2 button dahdi trunk, something like 1-8. However you said that the configuration did not "stick"? What happens if you set 1-8 and save the changes?

sgladio

Nothing actually. I would put in the value and then click on "Submit Changes". As soon as the page reloaded after the save, the field would be blank again. No errors or warnings anywhere.

I've worked around the issue for now by including the following in buttons_custom.cfg but this is not reflected in the FreePBX module.

[DAHDI/1]
type=trunk
label=DAHDI/Analog
channel=DAHDI/1
channel=DAHDI/2
channel=DAHDI/3
channel=DAHDI/4
channel=DAHDI/5
channel=DAHDI/6
channel=DAHDI/7
channel=DAHDI/8