FOP2 Community Forum

Thank you for the further clarification.

After further troubleshooting I realized this was due to a conflict between op_server.pl (fop1) and fop2 with the upgrade. Once I fixed that and cleared the browser cache it appears to function fine at this point.

I won't know for certain 100% until we have the system loaded down but it looks like fop2.2 is working fine on asterisk 1.8 so far.

As asterisk 1.8 is now out and elastix has begun testing/support of it when will fop2 be able to function with asterisk 1.8?

I just upgraded our system to asterisk 1.8 and now get the following error when trying to load fop2:
Couldn't load variables.txt?aldope=34677

I am more than willing to try tweaking fop2 to make this work I just need some guidance on what needs adjusting?

Upon looking at this further it looks like sometimes it does in fact catch calls and display on the trunk. However the majority of the time it is not catching which trunk the call came through.

All our inbound routes are going to either an IVR or call queues if that may help at all.

When doing such I see:

[SIP/Bandtel-1]
type=trunk
label=SIP/Bandtel-1
queuecontext=from-queue

[SIP/Bandtel-2]
type=trunk
label=SIP/Bandtel-2
queuecontext=from-queue

however when looking at sip show peers (right now no channels are active so it displayed nothing)

Bandtel-1/<our internal number>

same goes with Bandtel-2

Does FOP2 strip account numbers/extension off of the trunk or is it trying to match for the whole thing?

On our Elastix installation I recently just got fop2 up and running. It now is not displaying trunk activity at all (both inbound and outbound are not getting shown). However the trunk buttons got auto generated fine and are present. Also extensions and queues are showing activity as intended.

Wondering where I should be looking at for why this would happen?

I do have callevents=yes set in sip_custom.conf as mentioned in the elastixconnection guide (and queues have events turned on too). However if I need events for the trunk I am missing where I need to adjust that setting.