FOP2 Community Forum

I've got this working perfectly.

First I've created the extensions as DAHDI/<number_of_channel>, for example: DAHDI/3. I was creating this as ZAP/3, so it was writing at MySQL as ZAP/3.... make sence...
I still had the DAHDI/g0 created as OUT_1 at extensions_additional.conf. How I'm using the freePbx module, I got at freepbx ==> tools ==> Fop2 Buttons:
Zap/Dahdi Channels (Eg: 1-24): 1-2, because I've two interfaces to PSTN.

Now the fop2 is working perfectly and the status is showing how it should.

Thanks a lot.

I hope this post help someone in the future.

regards,
Leandro

Really sorry to delay....

the asterisk will detect when a Bridge/Link event is detected.But when I reload the config by FreePBX, the configurations turns back to ZAP/xx.

regards,

Leandro

It's working.... but, at fop2 it doesn't be red when someone "get a tone" (in analogic phone). I'm getting a red button only when I call to some place.
Is it possible?
I got DAHDI channels working at fop2 doing:

update fop2buttons set device="DAHDI/5" where fop2buttons.id=11;

thanks a lot admin.

Best regards

Leandro

I'm sorry,

I think I didn't understand....
Using the fop2admin freepbx, it will look at database, and bring the extensions using the database values (ZAP extensions), because the freePBX uses the database. So I need to uninstall the fop2admin freepbx module and install using the tar file? Using this, the FOP2 will show the buttons using the autoconfig-buttons-freepbx.sh script, because this script is called when one operator access fop2admin. Am I right?

Thanks a lot by your help.

Best regards,

Leandro

Thanks to reply.

What about this topic:
View Post 158,
I understood it must work as you said me....
This modification can be did by script modification? like autoconfig-buttons-freepbx.sh ?

I've openned a new topic at freepbx forum too. Maybe someone help me, and this modification should be a new fix to newer versions..
http://www.freepbx.org/forum/freepbx/ti ... nnel-issue

Thanks a lot.

best regards,

Leandro.

Hello all,

I've 5 DAHDI extensions and 2 DAHDI trunks at openvox A800.
When I call to external number, the trunks button was red, show "used" and show the destination number correctly. But the caller extension (DAHDI extension), for example, DAHDI/1 doesn't show any status, it continues green and available.
I'm using frePBX based system.

What configurations should I've to do, to show the status of DAHDI extensions ?

In my concept only getting the line tone by DAHDI extensions, the FOP2 should show as used, right?

thanks a lot.

Best regards,

Leandro.