I have a single IAX trunk connecting two Asterisk systems configured as peers. Only the outbound traffic is displayed in FOP2. How can I have the inbound traffic displayed as well? Thanks.
T
turboc
@turboc
Posts
-
IAX2 trunk shows outbound only -
High CPU applying changesRemoving the FOP2 module from FreePBX helps a lot. The config applies and the autoconfig-buttons procress runs for about 20 seconds. Any idea why the plugin would cause this problem?
-
High CPU applying changesWith the FOP2 service started, applying configurations changes in FreePBX causes the CPU to go over 80% for 60-120 seconds. What can be done to reduce the reload time? This does not happen with the FOP2 service is stopped. I am using FreePBX 2.9.0.12, Asterisk 1.8.7.1 and FOP2 2.26. There are about 259 extensions with 100 not active at this time, 7 queues, and 20 ring groups. Thanks.