Changing Attended Transfer key sequence from asterisk default

[IshMalik]

Hi

As I understand it, FOP2 uses the key sequence as defined in the features.conf to initiate an attended transfer, and it uses the default which is a single #

If I want to change this in the features.conf, is there a way to make the same change in the fop2 config?

Thanks in Advance

Ish

[nicolas]

FOP2 does not know the code sequence, it does not have to. It uses the atxfer AMI command and whatever code is configured is read by that command/asterisk itself. So, if you change the feature code, then I guess asterisk will just use the configured code, whichever it is. For example, on my system is not a single # but *2

[IshMalik]

That makes sense, I'll test it now.

[IshMalik]

Actually it's blind transfer that defaults to # but I'm guessing the same principle applies...

;blindxfer => #1 ; Blind transfer (default is #) -- Make sure to set the T and/or t option in the Dial() or Queue() app call!

[nicolas]

Blind transfers in FOP2 are done using the manager Redirect command. It does not use any feature code.

[IshMalik]

Thank you for your rapid help, my issue is resolved now.